Filter
Top Products
Technical Configuration (Analog/BRI) MultiVOIP User Guide
238
ISDN-BRI Parameter Definitions
Field Name Values Description
Select BRI
Interface
ISDNn
for n= 1-2 (410ST)
for n=1-4 (810ST)
In this field, you will choose which
ISDN port you are configuring.
The 410ST has two ISDN –BRI
ports (or “interfaces”); the 810ST
has four ISDN-BRI ports (or
“interfaces”). Each port has two
channels.
Layer 1
Interface
either “Terminal”
or “Network”
When “Terminal” is selected, it
indicates that the MultiVOIP
should emulate the subscriber
(terminal) side of the digital
connection. When “Network” is
selected, it indicates that the
MultiVOIP should emulate the
central office (network) side of the
digital connection.
If connecting to a telco or PBX
then choose “Terminal.” If
connecting to an ISDN phone or
terminal adapter, then choose
“Network.” Default = Terminal.
Dialing Options Inter Digit Timer
(value in
milliseconds)
Dialing options are relevant when
the MultiVOIP provides dial tone
either during an overlap receiving
mode or providing a second dial
tone. Default is 2000, which is 2
seconds. Range 250 ms to 10000
ms (1/4 sec to 10 sec).
Switch Information
Country see table below Country in which MultiVOIP is
operating with ISDN.
Operator see table below
Indicates phone switch
manufacturer/model or refers to
telco so as to specify the switching
system in question.
ISDN is implemented somewhat
differently in different switches
(different software stacks are used).