Filter
Top Products
5215 and 5220 IP Phone SIP User and Administrator Guide
- 50 -
− If you choose to change HTTP as well, proceed to “To enable or disable HTTP, or set
an automatic HTTP firmware upgrade” on this page. If you choose not to change
HTTP, press NOCHANGE. STORE CHANGES? appears on the display.
− Press YES. “SAVING TO NVRAM. Do not remove power” appears on the display,
followed by NVRAM SAVE COMPLETE and REBOOT NOW?.
− If you have completed all desired changes, press YES to reboot the phone for the
changes to take effect (when the date and time appear on the display, the phone is
ready for use). If you want to make further changes, press NO. EXIT MENU?
appears on the display. To return to the main menu, press YES.
OR
To enable or disable HTTP upgrade, or set an automatic HTTP firmware upgrade:
− At TFTP UPGRADE: <current status>, press NO. HTTP UPGRADE: <current status>
appears on the display.
− Press ON or OFF to enable or disable HTTP, or AUTO to set an automatic upgrade.
HTTP UPGRADE: <new status> appears on the display.
− Press NOCHANGE. STORE CHANGES? appears on the display.
− Press YES. “SAVING TO NVRAM. Do not remove power” appears on the display,
followed by NVRAM SAVE COMPLETE and REBOOT NOW?.
− If you have completed all desired changes, press YES to reboot the phone for the
changes to take effect (when the date and time appear on the display, the phone is
ready for use). If you want to make further changes, press NO. EXIT MENU?
appears on the display. To return to the main menu, press YES.
Phone Mode in the Boot Program
Changing the Phone Mode in the Boot Program
To change the phone mode to MiNET from SIP in the boot program:
1. Plug the DC adapter cord into the power input, and press and hold
and at the
same time until NETWORK SETTINGS? appears on the display.
2. Press NO until PHONE MODE? appears on the display, and then press YES.
PROTOCOL? appears on the display.
3. Press YES. PHONE MODE: SIP appears on the display.
4. Press CHANGE, and then press MiNET. PHONE MODE: MiNET appears on the display.
5. Press ACCEPT. STORE CHANGES? appears on the display.
6. Press YES. “SAVING TO NVRAM. Do not remove power” appears, followed by NVRAM
SAVE COMPLETE and REBOOT NOW?.
7. Do one of the following:
• If you have made all desired changes, press YES to reboot the phone for the
changes to take effect. When the date and time appear on the display, the phone is
ready for use.
• If you want to make further changes, press NO to exit to the main menu.