Filter
Top Products
5215 and 5220 IP Phone SIP User and Administrator Guide
- 16 -
Dialing by Name (5220 IP Phone only)
To dial by name:
1. Lift the handset.
2. Press NAME.
3. Enter the name of the party you want to call.
Note: If the name has more than 20 characters, only the last 20 characters will appear.
4. Press DIAL. The name is dialed, and the selected Line key turns green.
Note: To dial by a user ID name, you must be registered with a SIP Service Provider. For
more information, contact your Administrator.
Dialing by SIP URL or IP Address (5220 IP Phone only)
To dial by SIP URL or IP address:
1. Lift the handset.
2. Press URL, and then enter the SIP URL or IP address of the party you want to call.
Note: If the SIP URL exceeds 20 characters, only the last 20 characters will appear.
3. Press DIAL. The SIP URL or IP address is dialed, and the selected Line key turns green.
Note: For character entry information, see Entering Numbers and Letters on page 8.
Using Redial
Redial calls back the last party you dialed.
Note: Your phone will not remember the last outgoing call if power is lost.
To make a Redial call:
1. Lift the handset.
2. Press Redial. The last destination called is dialed, and the selected Line key turns green.
Answering Calls
An incoming call will ring on the first available line, or Line 1 if all lines are free. If all lines are
busy and Call Forward – Busy (see Enabling/Disabling Call Forward on page 19) is not
enabled, the caller gets a busy signal. While the phone is ringing, the Message
Waiting/Ringing Indicator flashes orange, the name of the caller appears and the associated
Line key flashes green.