Filter
Top Products
APPENDIX C: APPLICATION NOTES
DEFINITY Communications System
7400B Data Module
Page C-8
User’s Guide
CROSSTALK XVI
Crosstalk XVI is a data communications software package produced by
Digital Communications Associates.
Configuring the Software
1.
At the DOS prompt, type
xtalk
[ Enter ]
A title screen is displayed for a few seconds, followed by the
Status Screen
as shown below.
-------
CROSSTALK - XVI Status Screen
-------
I
NAme
CROSSTALK defaults (Hayes 2400)
NUmber
LOaded
STD
I
CApture Off
Communications parameters
------- Filter settings
-------
---------
--------
I
I
I
I
Full
DEbug
Off
LFauto
Off
SPeed 2400
PArity None
DUplex
DAta 8
ST
OP 1
EMulate None
TAbex
Off
BLankex
Off
POrt 1
MOde
Call
INfilter On
OUtfiltr On
--------------- Key settings --------------
-----SEnd control settings ----
I I
I
II
ATten
Esc
SWitch Home
COmmand ETX (ˆC)
CWait
None
BReak
End
LWait
None
------
-------
--------------
Available command files ---------------------------
I
1) AT&T
I
2) NEWUSER
3) SETUP
4) STD
2.
Choose the number next to the command file SETUP shown on
your Status screen or press the number for Setup and
[ Enter ]
again
to access the command line, then type LOad SETUP.
3.
4.
5.
6.
7.
To continue the
SETUP
program press
[ Enter ].
Select the letter next to Hayes Smartmodem (all models).
Select the letter next to Hayes Smartmodem 2400.
Select the COMmunication port to which your data module is
connected (typically COM 1).
Press [ Enter
], and then wait a few seconds as Crosstalk sets up the
7400B Data Module.