Filter
Top Products
20
Inter-Tel
®
Model 8662 Endpoint User Guide
BASIC
FEATURES
FEATURES USED WHILE ON A CALL
The following features are primarily used for active or incoming calls.
Placing Calls On Hold
When you place a call on hold, the held party hears music on hold or silence, depend-
ing on your system configuration. While the call is on hold, the system periodically
rings your endpoint as a reminder.
To place a call on hold:
1. Press or the HOLD menu button.
2. Hang up or place another call.
To return to a held call:
1. Lift the handset or press (handsfree).
2. Press or the flashing button.
If more than one call is on hold, switch between held calls (call hop) by pressing the
flashing button assigned to the call.
Using Call Park
Use Call Park to place calls on hold to a designated “orbit” location. After the call is
parked to the orbit location, it can be picked up (answered) by any subscriber.
To use Call Park:
1. During the call, press or the PARK menu button.
2. Enter a 1- to 10-digit orbit number (for example, ), and then press .
A confirmation notice appears.
3. Dial the extension number for which the parked call is intended, and then
announce the parked call and the orbit number.
4. Hang up. You are disconnected from both parties.
If the parked call is not picked up, it will be redirected to the subscriber who parked
the call after the Park Recall timer expires (about two minutes).
To pick up a parked call:
1. Press or the PKUP menu button.
2. Enter the orbit number, and then press .
LINE
LINE
PARK
1
1 1 #
SUCCESSFULLY
CALL PARKED
PICKUP
#