Filter
Top Products
DIAL MODE
38
Dialing a Number
Enter the desired number by pressing the 0-9, , and keys. Other
dialing functions are as follows:
• Only the last 8 digits dialed are displayed. To momentarily display
the upper 8 digits, press FCN .
• To erase the last digit, press the CLR key (hold it down to repeat). To
erase the entire number, press FCN CLR.
• To enter a pause, press FCN (each pause equals one character).
Sending the Number
Briefly press the PTT switch to access the radio system. Then to
send the number in the display, press FCN SND. The keypad remains
active while in a conversation to allow additional numbers to be dialed.
Simply press the PTT switch and dial the number. The number in the
display does not change when a number is dialed in this manner. If you
want to save the number in the display (see following information), make
sure you do so before the dial mode is exited.
Storing Numbers in Memory
Up to ten 16-digit numbers can be stored in memory and later
recalled. Proceed as follows to store a number:
1. Enter the number as described in the preceding “Dialing a Number”
section.
2. To store the number, press FCN STR and the memory location from
0-9.
3. If there is already a number in the selected location, it is replaced by the
new number. To clear a memory location, simply store a blank display.
#