Filter
Top Products
Entering the “sysObjectID” of a Power System
Copyright © 2005-2006 Eaton Corporation. All Rights Reserved.
IPN 997-00012-41D December 2006
6-5
Entering the “sysObjectID” of a Power System
“sysObjectID” is a unique identifier that allows the network management system to identify
an item (in this case a power system) on the network.
The unique identifiers are listed in the table below.
APS3-058:
1.3.6.1.4.1.1918.10.1
APS3-059:
1.3.6.1.4.1.1918.10.2
APS3-060:
1.3.6.1.4.1.1918.10.3
APS3-061:
1.3.6.1.4.1.1918.10.4
APS6-058:
1.3.6.1.4.1.1918.10.5
APS6-059:
1.3.6.1.4.1.1918.10.6
► To enter the “sysObjectID” of a power system using DCTools
1 From the DCTools System Summary (Home) screen, click the Configuration
hotlink and
then Communications
to display the Communications view.
2 Click the
button to the left of SNMP and scroll down to the bottom of the SNMP view.
3 Click the
button to the left of sysObjectID Component to display the sysObjectID
entry view.
4 Enter only the last three parts of the power system’s unique identifier into the
appropriate sysObjectID fields. (See Example 1 below.)
Example 1
The unique identifier of an APS6-058 power system is
1.3.6.1.4.1.1918.10.5.
The last three parts (1918.10.5) are entered as shown below.