Filter
Top Products
Commissioning
4-2
Copyright © 2005-2006 Eaton Corporation. All Rights Reserved.
IPN 997-00012-41D December 2006
Inserting the Access Power Rectifiers
Do NOT switch on the AC supply at this stage.
Step 1 – Unpack the rectifiers
Unpack the rectifiers and inspect them carefully for possible damage that may
have occurred in transit. Report any damage immediately, using a copy of the
Equipment Incident Report (located at the back of this guide) to supply all
relevant details. Fax the completed form to your local Powerware DC product
representative.
Keep the original packaging. You will need this if any equipment needs to be
returned to your nearest authorized service agent for replacement or repair.
Step 2 – Align the rectifier with the burst-out guides in the shelf
Step 3 – Push in the rectifier
To avoid injury to your hands, keep your fingers clear, as shown in
the diagram below.
1 Slowly push in the rectifier, sliding it along the burst-out guides, as shown
below, until it plugs firmly into the backplane connector.
2 Tighten the rectifier retaining screw with a Pozidriv® screwdriver.