Filter
Top Products
4. MISCELLANEOUS SETTINGS
4.1. Time and Date
a. Press MENU. The display will read “Phone Setting.”
b. Press the DOWN ARROW repeatedly until “Time/Date Set” appears in the display
c. Press the soft key under ENTER. The display will show the currently set time
d. Press the soft key under CHANGE
e. Enter the time as instructed in the display
f. Press DOWN ARROW
g. Press the soft key under CHANGE to choose between AM or PM
h. Press DOWN ARROW. The display will show the currently set date.
i. Press the soft key under CHANGE
j. Enter the date as instructed in the display.
k. Press MENU to exit.
Follow these same steps whenever you wish to adjust your system’s clock.
Note: If you subscribe to caller ID service from your local telephone company, there is no need to set
the time and date. This will be set automatically by the caller ID information, and will be updated with
each new call.
4.2. Message Waiting Lamp
The MSG lamp on the 2750 will flash when a voice mail signal is received. Note that you must be
subscribed to voice mail from your telephone company or be connected to a PBX which provides voice
mail signaling for this function to work correctly.
4.2.1. Message Waiting Line Selection
The 2750 can detect voice mail signals on any one of the four lines. By default, the 2750 is set to
respond to messages on Line 1. Follow the instructions below to set your voice mail detector to the
proper line.
a. Press MENU
b. Press the soft key under ENTER
c. Press DOWN ARROW repeatedly until “Telco VMWI” appears in the display.
d. Press the soft key under ENTER. The display will read “VMWI: LINE 1.”
e. Press the soft key under CHANGE repeatedly to select LINE 2, LINE 3, LINE 4, or OFF
4.2.2. Message Waiting Mode Selection
The 2750 can respond to either FSK or Stutter Dial Tone (SDT) message waiting signaling. To change
the mode follow the steps below after selecting the desired line as described in Section 4.2.1.
a. Press DOWN ARROW. The display will read “VMWI: FSK.”
b. Press the soft key under CHANGE to select SDT. This will activate the stutter dial tone
detector.
c. Press MENU to exit
21 2750 User Guide Version 1.3