Filter
Top Products
f. Use the dial pad numbers to enter the name for the desired station.
g. Press the soft key under SAVE.
Repeat steps “a” through “g” for any additional stations you wish to name.
The table below shows which dial pad numbers to press for all the different letters and special
characters.
Note that you can press the 0, *, and # buttons if you want those characters, and you can press the
down arrow button below the display to leave an empty space. Press the DELETE button to make
corrections.
0 0
1 , - ' & . ( ) 1
2 A B C a b c 2
3 D E F d e f 3
4 G H I g h i 4
5 J K L j k l 5
6 M N O m n o 6
7 P Q R S p q r s 7
8 T U V t u v 8
9 W X Y w x y 9
* *
# #
2.3. Line Configuration/Type
While you must share the same Line 1 telephone number at all the stations, you may choose to leave
some lines unconnected at particular stations or to connect private lines to Lines 2, 3 or 4 at particular
stations.
Common:This is the factory setting for all lines. This setting assumes that the telephone line is
connected to the same telephone line button at all stations.
Private:Use this setting at any telephone that is connected to a different telephone number than
the corresponding line at the other stations. For example, you may connect your private
telephone number to Line 3 at your station instead of connecting your station to the common
Line 3. In this example, you would set Line 3 at your station as PRIVATE.
Unconnected:Use this setting at any telephone that is not physically connected to all of its
lines. For example, you may install a 2750 4-line telephone in a room that is currently wired for
only lines 1, 2 and 3. In this example, you would set Line 4 at this station as UNCONNECTED.
10 2750 User Guide Version 1.3