Filter
Top Products
2-15
Cisco SIP IP Phone 7960 Administrator Guide
78-10497-02
Chapter 2 Getting Started with Your Cisco SIP IP Phone
Installing the Cisco SIP IP Phone
•
When configuring a domain name:
–
Press the Number soft key if entering a numerical ID or press the Alpha
soft key to enter a name.
–
If entering letters, use the numbers on the dial pad associated with a
particular letter. For example, the 2 key has the letters A, B, and C. For a
lower case “a”, press the 2 key once. To scroll through the available
letters and numbers, press the key repeatedly.
–
Press the << soft key to delete any mistakes.
•
After making your changes, relock configuration mode as described in the
“Locking Configuration Mode” section on page 3-2.
•
For a complete list of the SIP parameters that you can configure, see the
“Modifying the Phone’s Network Settings” section on page 3-2.
Procedure
Step 1
Press the settings key. The Settings menu is displayed.
Step 2
Highlight Network Configuration.
Step 3
Press the Select soft key. The Network Configuration menu is displayed.
Step 4
Highlight DHCP Enabled.
Step 5
Press the No soft key. DHCP is now disabled.
Step 6
Highlight and configured each of the following parameters:
•
IP Address—IP address of the phone.
•
Subnet Mask—IP subnet mask used by the phone.
•
TFTP Server—IP address of the TFTP server from which the phone
downloads its configuration files and firmware images.
•
Default Routers 1 through 5—IP address of the default gateway used by the
phone. Default Routers 2 through 5 are the IP addresses of the gateways that
the phone will attempt to use as an alternate gateway if the primary gateway
is not available.