Setting the access pause
You can insert a pause or change the length of
a pause to suit different access codes.
The handset must be switched ON.
• Press the STO button.
• Press #.
• Press the 1 button
• Enter the system code. (Factory setting is
0000. To change it see page 16.) Each digit
you enter erases one dash on the display.
• Press the
LNR
button.
• Enter one of the three-digit codes above to
set the length of pause you want.
• Press the
STO
button to confirm.
Code PAUSE
0 2 4 1 second
0 2 5 2 second
0 2 0 3 second
0 2 1 6 second
2 5 3 To clear all
access codes
43
Using your Diverse 1015
with a switchboard
If you are experiencing problems, please call the
Diverse Helpline on 0345 908070.
To insert an access code
The handset must be switched ON.
• Press the STO button.
• Press the # button.
• Press the 0 button.
• Enter the system code. (Factory setting is
0000. To change it see page 16.) Each digit
you enter erases one dash on the display.
• Press the
LNR
button.
Display shows
A
–-
–-
–-
.
• Enter the access code (for example 9).
If you want to enter additional access codes,
press
LNR again, followed by the next code,
and so on.
• Press the STO button to confirm.
Notes
• You can store RCL, ✱, and
#
as well as the
digit keys 0-9.
• You can enter up to three PBX access codes, each
one to three digits long.
• You may find it useful to enter 144 (for BT
Chargecard access) as one of the access codes,
together with an access pause of six seconds – see
‘Setting the access pause’ opposite.
STO
0
LNR
STO
1
LNR