Filter
Top Products
- 6 -
f. Enter the activation code into the Pocket PC when prompted and tap
“Next”.
g. Once complete, you will see the message ‘license activated successfully’.
Select Finish.
Changing the Voice Option at Any Time
To change the Pre-Recorded sound files option:
1. From the Home screen select Menu > Trip > Settings.
2. Select Language and Speech.
3. Use the up and down arrows to choose a language and voice option.
4. Tap OK.
Speech Volume
To hear CoPilot’s voice prompts, the volume on your Pocket PC must be turned
all the way up. In the Pocket PC Start menu, go to Settings and tap on Sounds
and Notifications. Under System Volume, move the slide bar all the way to
the right. Or use your Pocket PC’s keypad when CoPilot is open: tap up until you
reach the maximum volume.
Product Key Entry and Activation
The fi rst time you launch CoPilot on your Pocket PC you will be prompted
for your product key. You can fi nd this key behind the scratch-off panel on the
supplied product key card. Scratch off the panel and input the product key
carefully. Press Done.
TIP: It is recommended that you switch off T9 predictive text entry when
inputting your product key.
You will now be asked to activate your CoPilot license within 3 days. Select one
of the three methods below to activate your CoPilot license. Alternatively, press
Menu followed by Later if you would prefer to activate afterwards at your
convenience, within the next 3 days.
Three Ways to Activate:
1. Recommended: Automatic Activation using your Pocket
PC’s Wireless Internet Connection
a. When prompted to activate, Tap “Next” to begin the process.
b. Enter your email address and tap “Next” to automatically activate.
c. Once complete, you will see the message ‘license activated success-
fully’. Select Finish.
d. Activation is now complete.
2. Automatic Activation via an Internet-connected Desktop
PC or Laptop
Connect your Pocket PC to an Internet-enabled Desktop or Laptop using the
supplied Synchronisation cable, and Microsoft ActiveSync software on your
desktop PC or Laptop. Make sure your desktop/laptop is connected to the
Internet, then follow the steps outlined above.
3. Manual Activation (requires an Internet-connected
computer)
a. When prompted to activate, Tap “Next” to begin the process.
b. Enter your email address and tap “Next”.
c. Check the box that says “Check Here if you do not have any access
to the internet” and tap “Next”
d. On the next screen you’ll see your Product Key and License ID. You need
this information to manually activate CoPilot as in the following steps:
e. On a desktop/laptop go to the Internet site http://activate.alk.com and
enter the information. You will be given an activation code