Filter
Top Products
- 4 -
Uninstalling a Previous Version
If you have a previous version of CoPilot installed, uninstalling before you install
a newer version is optional.
NOTE: If you’re uninstalling CoPilot from a Pocket device and installing the
same version on another device, you must deactivate the software on the first
device before installing it again.
When uninstalling CoPilot, your GPS receiver cannot be attached.
Before uninstalling, you must disconnect the receiver and perform a soft restart.
Then follow the steps outlined below:
(1) On your Pocket PC:
NOTE: It is recommended to perform a soft reset on your Pocket PC before
and after uninstalling CoPilot.
1. Tap the Start menu and select Settings > System > Remove Programs
2. Select the CoPilot application and tap Remove.
3. Select Pocket Speech and tap Remove.
4a. If you stored map data on a storage card:
i. Delete the CoPilot folder on the storage card. Tap Start, then Programs
> File Explorer > My Device > SD Card, then tap and hold on the CoPilot
folder and select Delete from the menu.
4b. If you stored map data on your device memory:
i. Delete the CoPilot folder on My Device. Tap Start, then Programs > File
Explorer > My Device, then tap and hold on CoPilot and select Delete
from the menu.
(2) On your Desktop/Laptop computer:
1. Select Start menu > Settings > Control Panel.
2. Double-click Add/Remove Programs.
3. Select the CoPilot application and click on the Remove button.
4. If asked to confirm the removal of CoPilot and all of its
components, select Ye s .
5. If asked to remove shared files during the uninstall process, select
No To All.
6. Select Start > Search > Files or Folders and find the CoPilot folder.
7. Right-click the CoPilot folder and select Delete.
Connecting Your Pocket PC
NOTE: If a Quickstart installation memory card was included with your purchase
of CoPilot, you do not need to do this.
In order to successfully transfer data from your desktop to your Pocket PC,
you must have Microsoft ActiveSync 3.1 (or later) installed. This software is
necessary to connect the two machines and is provided by your Pocket PC
manufacturer. If you did not receive this software with your mobile device,
contact the distributor immediately.
1. When connecting your Pocket
PC, if you have not set up a
partnership between your Pocket
PC and your desktop, you will be
prompted to do so. This is not
required. If you choose not to set
up a partnership, select Guest
partnership, and
you will be logged
in as a Guest and
ready to transfer
data between
machines.
2. If you have set up a partnership
in the past, or choose to do so at
this point, be sure to allow your
Pocket PC to synchronize with
your desktop/laptop prior to
launching CoPilot.
NOTE: If your desktop/laptop
computer does not seem to be
recognizing the connection with
your Pocket PC, select Connection
Settings... from the drop-down
File menu, and make sure you're
connected using the appropriate
Port. Then click Get Connected...
in the File menu and follow the on-
screen instructions.