Filter
Top Products
ZB2430 ADDRESSING
44
8. Wait for command response:..................................................0xCC 0x44 0x41 0x54
9. Send data to device
Figure 16: ZigBee Addressing by MAC - Node 0 to Node 2
Next, assume that Node 1 needs to send a message to Node 2, which is also out of it’s range. The procedure is the
essentially the same as above (see Figure 16: "ZigBee Addressing by MAC - Node 0 to Node 2"). Note that the
underlined values will vary from radio to radio.
1. Enter AT Command Mode: .....................................................0x41 0x54 0x2B 0x2B 0x2B 0x0D
2. Wait for command response:..................................................0xCC 0x43 0x4F 0x0D
3. Discover NWK Address:..........................................................0xCC 0x8D 0x22 0x11 0x33
4. Wait for command response:..................................................0xCC 0x14 0x3E
5. Write 16-bit Destination NWK address:...................................0xCC 0x10 0x00 0x14 0x3E
6. Wait for command response:..................................................0xCC 0x00 0x14 0x3E
7. Exit AT Command Mode:........................................................0xCC 0x41 0x54 0x4F 0x0D
8. Wait for command response:..................................................0xCC 0x44 0x41 0x54
9. Send data to device