39
ZB2430 User’s Manual - v1.6
EEPROM PARAMETERS
www.aerocomm.com
Stale Limit 0x4F 1 0x01-0xFF 0x32 Specifies amount of time to keep a radio in the
Radio Table without having received a packet
from that particular radio. Prevents retries from
being interpreted as new packets. Adjustable
in 100 ms increments.
Control 1 0x56 1 0x01 - 0xFF 0x43 Settings are:
bit-7: RS495 DE/RE
0 = Disabled
1 = Enabled
bit-6: Reserved
bit-5: Reserved
bit-4: Auto Destination
0 = Use Destination Address
1 = Use Auto Destination
bit-3: Auto Channel
0 = Disabled
1 = Enabled
bit-2: Reserved
bit-1: Reserved
bit-0: Reserved
Interface Timeout 0x58 1 0x02 - 0xFF 0x04 Specifies a byte gap timeout, used in conjunc-
tion with RF Packet Size to determine when a
packet coming over the interface is complete.
Note: 1 ms per increment.
RF Packet Size 0x5A 2 0x0001 -0x0054 0x0054 Specifies the RF packet size.
Note: RF packet size needs to be set to a mini-
mum of six bytes in order to use the Enter AT
command.
CTS On 0x5C 2 0x0001 - 0x01C0
Coordinator
/Router:
0x0001 - 0x0416
End Device:
0x0001 - 0x0096
Coordinator
/Router:
0x0190
End Device:
0x50
CTS will be deasserted (High) when the Trans-
mit buffer contains at least this many characters
CTS Off 0x5E 2 0x0001 - 0x01C0
Coordinator
/Router:
0x0001 - 0x0416
End Device:
0x0001 - 0x0096
Coordinator
/Router:
0x0180
End Device:
0x50
Once CTS has been deasserted, CTS will be
reasserted (Low) when the transmit buffer con-
tains this many or less characters.
Power Control 0x63 1 0x00 - 0x03 0x00 Determines output power of transceiver.
ZB2430-Q ZB2430-D
0x00: 17 dBm 0x00: 3 dBm
0x01: 11 dBm 0x01: -3 dBm
0x02: 5 dBm 0x02: -9 dBm
0x03: -1 dBm 0x03: -15 dBm
Destination ID 0x76 2 0x0000 - 0xFFFF R/E: 0x0000
C: 0x0001
Specifies destination for RF packets.
PAN ID 0x78 2 0x0000 - 0x3FFF 0x0001 Similar to network name. Radios must have the
same PAN ID to associate with each other.
Table 9: EEPROM Parameters
Parameter
EEPROM
Address
Length
(Bytes)
Range Default Description