Filter
Top Products
www.aerocomm.com
C ONFIGURING THE ZB2430
7
The ZB2430 can be configured using the CC Configuration Commands. These commands can be issued using either
Hardware or Software Configuration. To use Hardware Configuration, the Command/Data pin of a transceiver must be
asserted Low. Software Configuration can be used by entering AT Command Mode before issuing the CC
commands.
Figure 11: ZB2430 Configuration Flow
Use AT
Commands?
Receive Mode
Assert CMD/Data
Pin Low
(Hardware
Configuration)
Send Enter AT
Command Mode
command
(Software
Configuration)
Send CC
Commands?
Exit Command
Mode
In AT
Command
Mode?
Send CC
Command
Send Another
CC Command?
Send Exit AT
Command
De-assert CMD/
Data pin High
Yes
Yes
Yes
Yes