Filter
Top Products
Revision History
Revision Description
Version 1.0 7/21/06 - Initial Release Version
Version 1.1 7/25/06 - Updated Pin definitions, corrected status request
command to display 0x00 as firmware version, updated CC 08,
CC 21 and EEPROM byte write commands. Corrected PAN ID
EEPROM address to address 0x78. Updated Future
Enhancements section.
Version 1.2 9/15/06 - Changed Reset to active Low. Changed pin 20 to
Sleep pin and is active Low. Added second mechanical
drawing.
Version 1.3 1/18/07 - Corrected Read Temperature command.
Version 1.4 7/6/07 - Internal Release.
Version 1.5 7/17/07 - Added pinout for pluggable module.
Version 1.6 8/24/07 - Added API command set. Added Neighbor, Route, &
Radio Table commands. Added Energy scan command. Added
NV with soft reset command. Added static network parameters
information. Updated Broadcast section. Updated Serial
Interface section. Updated Channel Mask section. Added
power-down modes. Corrected status request response.
Added MAC retries to EEPROM parameter list.
Version 1.7 Corrected Read Channel Command (was CC 02 00; changed to
CC 02)
Version 1.8 12/17/07 - Updated Compliancy Information. Added approval for
ZB2430-D. Updated Approved Antenna List.
Version 1.9 1/4/08 - Added new EEPROM parameters for firmware version
1.6 - End Device poll rate, Parent Hold Message, End Device
Wake Time, End Device Wake Poll rate, Stop Bit Delay, Modify
Wake upon RX, Reload Sleep, NV Restore enable/disable, &
RS485 DE/RE.
Version 2.0 3/1/08- Updated ZB2430 Features, Updated Current Draw for
High Power module, Updated RF Packet Size in RX Data Buffer
and CTS,
Updated Read Digital Input, Updated Read ADC,
Updated Write Digital Output, Removed Discover 16-bit NWK
Address command, Added Read Voltage cmd, Added Restore
Default cmd, Added End-to-End Retries to EEPROM Parameters
Table, Updated CTS On/Off Thresholds, Updated Read
Neighbor Table Command