Aastra Telecom DT390 Cordless Telephone User Manual


 
8. Press the answering button on the headset.
Note: Calls can be answered at any time even during programming, or
while keying in a number. When the phone is in idle mode, you
can change the answering method, see Section 15.6.
Other answering methods; Automatically or Loudspeaking, can be set from
the Settings tab, see Section 15. When automatic answering is enabled, an
incoming call will be answered automatically after approximately one
second.
6.1.1 Call pick-up
To answer a call to a phone in another room:
1. Call the ringing extension and press
You will hear a busy tone.
2. Press 8.
Note: France and New Zealand press 4; Sweden press 6.
6.1.2 Mute ring signal temporarily
If the phone rings at an inconvenient moment:
1. Press
to suppress the ringing.
All alert signals, including the vibrator, will silence for this specific call.
2. Press
to answer the call.
6.1.3 Switch ring signal off
You can set your phone to silent ringing, when your phone is in idle mode:
Press and hold
to switch the ring signal on or off. When switched
off,
is shown. All alert signals will silence until the ring signal is
switched on again. If the vibrator is set to On when silent, it will alert
you of new calls, messages and alarms. See Section 15.1.3.
6.1.4 Rejecct a call
If you do not want to take the call, when the phone rings:
Press
to reject the call. The call is disconnected.
1424_EN_LZT103087.doc Rev B2 2009-09-11
© Copyright Aastra Telecom Sweden, 2009.
All rights reserved.
33