3Com 900-0208 Telephone User Manual


 
Troubleshooting Problems 123
My telephone is not
forwarding my incoming
calls to my voice mailbox.
In NBX NetSet > User Information > Call Forward
Default, verify that you have selected Forward to
Voice Mail as your call coverage point. For details, see
“Forwarding Incoming Calls”
in Chapter 4.
I added a One-Touch speed
dial, but the telephone
does not dial that number.
Use only numeric characters in your Speed Dial setup.
For details, see “Special Case: One-Touch Speed Dials”
in Chapter 5
.
I try to pick up a call ringing
on another telephone using
Directed Call Pickup, but it
fails.
The telephone that you are using to pick up the call
may not be in the same group as the telephone that is
ringing and the telephone group to which the ringing
telephone belongs does not allow nonmember pickup.
See “Call Pickup” in Chapter 6.
My telephone keeps
ringing after I pick up the
handset.
Your telephone may have lost connection to the
system immediately after a call came in. Remove the
Ethernet cord from the jack, then re-insert it into
the wall jack.
Wait a few seconds. If the telephone continues to
ring, disconnect the electrical power for your
telephone, and then plug it back in.
The display panel shows
“Wait for NCP.”
Your telephone may be disconnected from the system.
Hang up your telephone and wait a few seconds. Then
pick up the handset. If the message still appears on
your telephone display panel, contact your
administrator.
I dial an external call but
nothing happens.
You may be required to enter an account code to
complete the call. See “Account (Billing) Codes”
in
Chapter 6
.
Table 12 Possible Problems (continued)
Possible Problem Suggested Solutions