Filter
Top Products
TERMINAL SETUP
Connect Optional Device(s)
OMNI 37XX INSTALLATION GUIDE 19
If a cable is not already connected to the smart card reader or PINpad 501,
insert the small modular plug on one end of the interface cable into the
optional device’s modular jack.
3 Insert the larger RJ45-type connector on the other end of the PIN pad cable
into the PIN pad serial port on the terminal’s back panel.
Figure 12 provides an example of a Smart Card Reader connection to a Bar
code and PIN pad serial port.
Figure 12 Smart Card Reader Connection
Connect Check
Reader
The Omni 37xx base supports two VeriFone check readers: CR 600 and
CR 1000i. Contact your VeriFone representative or visit the online store at
www.verifone.com for information on these devices. Figure 13 provides an
example of a peripheral connection to an RS232 port.
CAUTION
Check readers require a separate power source. Before connecting a check
reader or similar device, remove the power cord from the back of the terminal and
be sure the LED is not lit.