Filter
Top Products
TERMINAL SETUP
Connect Optional Device(s)
18 OMNI 37XX INSTALLATION GUIDE
9 Close the cardholder by pivoting the cover back to its connector base
(see Figure 11).
10 Lock each MSAM cardholder by sliding its locking plate, as shown by the
LOCK arrow, until the plate stops (see Figure 10).
11 Replace the MSAM compartment door and reinstall the locking screw
(see Figure 9).
Connect
Optional
Device(s)
The Omni 37xx supports some peripheral devices designed for use with electronic
point-of-sale terminals.
Use the two ports on the back panel to connect up to two optional devices.
The following sections discuss the most common optional devices supported by
this terminal.
Other optional devices may be supported. For more information, please contact
your VeriFone distributor.
Connect PIN Pad,
Smart Card
Reader, or Bar
Code Wand
To Connect PIN Pad, Smart Card Reader, or Bar Code Wand
1 If necessary, insert the small modular plug on one end of the PIN pad cable
into the PIN pad’s modular jack.
For a bar code wand, insert the RJ45-type cable into the PIN pad serial port
on the back panel.
2 If installing a PINPad 101, PINpad 201 or PINpad 1000, position and insert the
grommet to secure the cable connection.
CAUTION
Before connecting any peripheral device, remove the power cord from the back of
the terminal and be sure the LED is not lit. Reconnect the power cord only after
you are finished connecting the peripheral device(s). For complete information
about peripheral installation and use, refer to the user documentation supplied with
those devices.
Table 2 Optional Devices Supported
Optional Device Connection Port
Barcode PIN Pad
CR 600 RS232
Console PIN Pad
External LAN RS232
PIN Pad PIN Pad
RS232 Electronic Cash Register RS232
NOTE
RS232-type devices do not work with the PIN Pad port; PIN Pad-type devices do
not work with the RS232 port. If an optional peripheral device does not function
correctly, check the port connection.