Filter
Top Products
TERMINAL SETUP
Install/Replace MSAM Cards
OMNI 37XX INSTALLATION GUIDE 17
Figure 9 MSAM Compartment Door and Locking Screw
4 The MSAM cardholders are now accessible. Each cardholder consists of a
hinged tilt-up cover attached to a connector base.
5 To unlock a cardholder, slide its locking plate to the unlocked position, shown
by the OPEN arrow (see Figure 10).
Figure 10 MSAM Cardholder Close-Up
6 Open the cardholder by pivoting the cover on its hinges away from its
connector base (see Figure 11).
Figure 11 Using an MSAM Cardholder
7 Remove any previously-installed MSAM card by sliding the card from the
cover.
8 Install an MSAM card by aligning the card and carefully sliding it within the
guides on the cover until it is fully inserted.
MSAM
LOCKING SCREW
COMPARTMENT
DOOR
OPENING THE
REMOVING A INSTALLING A CLOSING THE
CARDHOLDER
SAM CARD SAM CARD CARDHOLDER
NOTE
Before inserting the MSAM card, position it as shown in Figure 11, with the card’s
gold contacts facing the smart car reader end of the terminal. The cardholder
connector base has a set of contacts and a notch post on one corner to ensure the
MSAM card is positioned correctly when the cover is closed. The MSAM card has
a notch on one corner to ensure that it fits into the connector base in only one way.