Filter
Top Products
[ 49 ]
Setting the call screen
You can screen calls when the Call Screen function is set to On.
1) Press clock/MENU six times.
The current Call Screen setting (On or Off) appears on the base.
2) Press skip/SELECT or repeat/SELECT to choose On or OF.
3) Press SET. A confirmation tone sounds, and the system announces the new setting.
Screening a call
From the base
To screen an incoming call, do the following steps as follows:
1) After the answering system answers, the base speaker will let you
hear the calls as the machine records the message. To adjust the
volume, press /vol/ or /vol/ .
To mute the call screen temporarily, press play/stop when
the system is answering.
2) To answer the call, press or pick up the handset from the base
(when AutoTalk is set to On). If the handset is away from the base, press ,
speaker or any number key, , or (when Any Key Answer is
set to On).
The answering system will disconnect automatically.
From the handset
1) Press when the system is answering.
To mute the call screen temporarily, press when the system is answering.
2) To answer the call, press , otherwise press to cancel the call screen
and the system return to standby mode.
• If you set the call
screen to off, you
can not screen a call.
• If you press
, call
screen will be
canceled and the
handset is put in
talk mode.
• If you press
while
another handset is
screening a call, you
will hear a beep and
you can not screen
a call.
UP354BH(WDECT2355+2) OM 5/14/04 10:52 AM Page 49