Filter
Top Products
[ 37 ]
CHAIN DIALING
The memory locations in the handset are not limited to phone numbers. You can
also store a group of numbers (up to 20 digits), that you need to enter once your
call connects. This is referred to as Chain Dialing.
An example of this is a bank account number. Store the account or special number
in one of the phonebook locations. (Refer to “Storing Phone Numbers, Names,
Distinctive Rings and Speed Dial” on page 30.) When you call your bank and you are
prompted to enter the account number, scroll through your phonebook locations
until you find your account number, and then press .
MEMORY DIALING (BASE ONLY)
You can store 10 phone numbers in the base, and make calls with memory dialing
from the base.
Storing Phone Numbers
1) Press mem in standby mode.
2) Enter the number you wish to store. (The number cannot exceed 20 digits.)
3) Press mem. Enter the memory location number (0-9) on the keypad.
You will hear a confirmation tone.
Making Calls with Memory Dialing
1) Press in standby mode.
2) Press mem. Enter the memory location number (0-9) to dial the number.
Deleting the Stored Data
1) Press mem in standby mode.
2) Press mem again.
3) Enter the memory location number (0-9) you wish to delete.
You will hear a confirmation tone.
• The 10 memory
locations in the base
are independent from
the handset.
• If you have not
pressed any key for
30 seconds, the
phone returns to
standby mode.
UP354BH(WDECT2355+2) OM 5/14/04 10:51 AM Page 37