Filter
Top Products
[ 29 ]
FLASH AND CALL WAITING
FIND HANDSET
If you have Call Waiting service and a call waiting tone
sounds while you are on a call, press (or flash
on the base) to accept the waiting call. There is a short
pause, and then you will hear the new caller. To return to
the original caller, press (or flash on the
base) again.
To locate the handset, press mute/find handset on the base
when the base is in standby mode. All registered handsets
beeps for 60 seconds, and Paging appears on the handset
display. To cancel paging, press any key on the handset or
mute/find handset on the base.
When speaking on the base
1) Press or speaker on the handset to
initiate the 3-way conversation.
2) To hang up, return the handset to the cradle, or press
key on the handset. The base will still be connected
to the call.
NEW MESSAGE LED
The new message LED on the handset flashes when you have new messages in
your answering system. The LED stops flashing when all new messages are played
back (see "Using your Answering System" on page 50).
UP354BH(WDECT2355+2) OM 5/14/04 10:51 AM Page 29