Filter
Top Products
[ 14 ]
Entering the Menu
1) Press the /del key in standby mode.
2) Use /vol/ or /vol/ to move the pointer to
a desired main menu (DirectLink Mode, Room Monitor,
Handset Setup, Answ. Setup, Global Setup, and
System Reset).
3) Press to select the desired main menu.
4) Use /vol/ or /vol/ to select a desired submenu, and then press
to enter.
In the submenu, use /vol/ or /vol/ to select an item. Press
to confirm your selection. For detailed instructions, see the following sections for the
desired submenu.
5) To exit the menu, press or place the handset to the cradle.
DirectLink Mode
Entering the Two Way Communication between
the Handsets Anywhere without the Base
1) Enter the DirectLink Mode menu (see “Entering the
Menu” on page 14). To enter DirectLink mode
press [SELECT] appears.
2) Press to enter the DirectLink mode. You will
hear a confirmation tone, and DirectLink Mode Complete appears.
To adjust ringer volume, press /vol/ or /vol/ to select one of three
ringer volume (off, low, or high).
3) To return back to the normal mode, exit the DirectLink mode. To exit the DirectLink
mode, press /del, and then , or return the handset to the cradle.
DirectLink Mode Cancel appears.
To enter
DirectLink mode
press [SELECT]
SETTING UP THE MENU
DirectLink Mode
Room Monitor
Handset Setup
To back to the
previous screen,
press /del.
UP354BH(WDECT2355+2) OM 5/14/04 10:49 AM Page 14