Filter
Top Products
[ 47 ]
Setting the ring time
The ring time setting allows you to set the number of rings the caller hears before your
answering system plays the outgoing message. You can set the ring time to answer after
four, six, nine rings. If you enable the Toll Saver (TS setting), the answering system picks
up after six rings if you have new messages, and after nine rings if there are none. This
way, if you make a long distance call to check your messages, you can hang up after the
sixth ring to avoid billing charges.
1) Press clock/MENU three times.
The current ring time setting (4, 6, 9, (Toll saver)) appears on the base and it
is announced.
2) Press skip/SELECT or repeat/SELECT until the desired ring time appears.
3) Press SET to select the new ring time.
A confirmation tone sounds, system announces the new ring time.
Selecting the message record time
You have three record time options. The options “1 minute” or “4 minutes” set the
duration for recording the incoming messages. “Announce only” answers the call with the
preset greeting or your personal greeting but prevents the caller from leaving a message.
1) Press clock/MENU four times.
The current recording time (1 minute, 4 minutes, A (Announce only)) appears on the
base and it is announced.
2) Press skip/SELECT or repeat/SELECT until the desired message record
time appears.
3) Press SET to select the new recording time.
A confirmation tone sounds, system announces the new record time.
UP354BH(WDECT2355+2) OM 5/14/04 10:52 AM Page 47