Filter
Top Products
6. Quick Installation
WARNING
The minimum requirements for using UIP312 are network configuration such as DHCP, IP
Address, Net Mask, Gateway, DNS, etc., and GK address and alias configuration.
If above requirements are not satisfied, consult your network administrator.
6.1 Installing the Phone
Unpack all the contents you received with your Phone.
Connect your activated Local Area Network (LAN) cable to the UPLINK port on the back of the
Phone as shown in Figure 1
Connect the power adapter to an AC outlet and connect the jack to the DC-IN-18V on the back
of the Phone (See Note).
If you use this phone with a PC, connect one end of the UTP cable (2m) to the Downlink port
and the other end to your PC’s LAN card. (The Phone has an internal SWITCH HUB in itself.)
(DC-IN-18V)
UPLINK DOWNLINK
Figure 1
Note: Use only the power adapter provided by manufacturer. Some adapters provide too
much voltage and can damage the phone. If the adapter does not provide enough
power, the phone will not operate.
Page 7