Filter
Top Products
62
3. Scroll to Scan Hits On or Off and press Pgm/E to save and
return to the Close Call menu. (Default = O)
You can also store these temporary frequencies into channel
storage banks when you receive them in Scan mode and scroll
to them in Scan Hold mode.
See also Storing Found Search Frequencies on page 55.
Close Call Delay
This setting controls how long the scanner stays on the
frequency after a transmission ends before resuming Close Call
operation. If you select a minus delay time, the scanner stops
on the transmission for the preset time and then automatically
resumes scanning. (Default = 2 seconds)
1. Press Func then Hold to view the Close Call menu.
2. Scroll to Set Delay and press Pgm/E.
3. Scroll to select the delay time from following options:
• -10 sec - resumes after 10 seconds.
• -5 sec - resumes after 5 seconds.
• 0 sec - resumes immediately.
• 1 sec - waits 1 second for a reply then resumes.
• 2 sec - waits 2 seconds for a reply then resumes.
• 3 sec - waits 3 seconds for a reply then resumes.
• 4 sec - waits 4 seconds for a reply then resumes.
• 5 sec - waits 5 seconds for a reply then resumes.
4. Press Pgm/E to save and return to the Close Call menu.