22
ADJUSTING THE BELT CLIP
The factory-attached belt clip makes it easier to carry the
scanner. Use a Phillips screwdriver to adjust (loosen) the
mounting screws or remove the belt clip completely.
POWERING THE SCANNER
You can power the scanner using alkaline (ALK) non-
rechargeable batteries (not supplied) or the included Nickel
Metal-Hydride (Ni-MH) rechargeable batteries. [Uniden provides
a USB cable to charge the Ni-MH batteries on initial installation
and to recharge them through your computer (or through a
power adapter that provides USB charge power (not included,
but available at many retailers).]
Inside the battery compartment is a switch to set the unit to
either ALK or Ni-MH.
WARNING! Non-rechargeable batteries can get hot or burst
if you try to recharge them.
CAUTIONS:
• When
BATT
ashes in the display and the scanner beeps
every 15 seconds, recharge or replace the batteries.
• Use only fresh batteries of the required size and
recommended type.
• Always remove old or weak batteries. Batteries can leak
chemicals that destroy electronic circuits.
• Do not mix old and new batteries, dierent types of batteries
(standard, alkaline, or rechargeable), or rechargeable
batteries of dierent capacities.