33
2. Turn SCROLL CONTROL to adjust the volume level from 0
to 15.
3. Press SCROLL CONTROL to set the volume.
4. To exit Volume Level mode, press SCROLL CONTROL
again or wait 10 seconds to return to the previous mode.
Adjusting the Squelch
To adjust the squelch level, press FUNC, then press SCROLL
CONTROL. When the squelch level indicator and battery voltage
appear, turn SCROLL CONTROL to change the squelch level
from 0 to 15.
1. Press Func, then press SCROLL CONTROL. The squelch
level indicator and battery voltage appears.
2. Turn SCROLL CONTROL until the audio mutes. If the
scanner picks up unwanted partial signals or very weak
transmissions, increase the Squelch setting to increase the
signal level required to open squelch. To listen to a weak or
distant station, decrease the Squelch setting.
3. Press SCROLL CONTROL to set the desired level and return
to the previous mode.
Setting the Backlight
Press
to turn on the backlight on and o.
1. Press Func and
to view the Display/Charge menu.
2. From this menu, scroll to Set Backlight from the
submenus. Press SCROLL CONTROL.
3. Scroll to select one of the following settings:
• Always O - Backlight is always o.