Filter
Top Products
A-3
Entering Characters
The following dial buttons are used for entering characters. Press the left/right
direction buttons to move a cursor. Then, modify or insert the desired characters.
Entering Alphabet
Press the [Menu] button repetitively to select character input mode.
The location of alphabet letters on dial buttons is described as follows:
Table A.2 Location of Alphabet Letters on Dial Buttons
Dial
Button
Alphabet Dial Button Alphabet Dial Button Alphabet
1
Q Z
2 A B C 3 D E F
4 G H I 5 J K L 6 M N O
7 P Q R S 8 T U V 9 W X Y Z
* 0 #
♦ Press the button repetitively until the desired alphabet letter appears.
e.g.) Press the button [5] twice to enter K.
Press the button [7] four times to enter S.
♦ To enter another alphabet letter from the same button sequentially, enter the
first alphabet letter, wait for about 3 seconds, and then press the button again.
♦ Perform the following procedure to insert blank.
− Press the right direction button to insert blank.
− To insert blank between the entered characters, press the left/right
direction buttons to move a cursor to a character that will be right next
to the blank, and press the dial button [0] once.
♦ Press the [Cancel] button to delete any characters. Press the [Cancel] button
briefly to delete the character left to the cursor one by one. Press the [Cancel]
button for more than 2 seconds to delete all characters left to the cursor.