Filter
Top Products
Operation
20
1. When the phone is in the standby
mode, press and hold
CID/MENU.
2. Press
VOL/RING key to move the
pointer down to "
Area Code
".
3. Press
SELECT/CH. Ô
4. Use the number keys (
0 - 9), or
DELETE/TRANS to enter the three-digit
area code.
5. Press
SELECT/CH. A confirmation tone
sounds and the displayed area code is
entered.
6. Press
END or return the handset to the
base unit to complete the setting. The
handset returns to the standby mode.
Choosing the Dialing Mode
Most phone systems use tone dialing which
sends DTMF tones through the phone lines.
However, some phone systems still use
pulse dialing such as in rural areas. Ô
The default setting is tone dialing.
Depending on your dialing system, set the
mode as follows:
1. When the phone is in the standby
mode, press and hold
CID/MENU.
2. Press
VOL/RING key three times to
select "
Dial
".
3. Press
SELECT/CH to toggle between
"
Tone
" and "
Pulse
" for each setting.
4. Press
END and then return the handset
to the base unit to complete the setting.
The handset returns to the standby
mode.
Ô NOTES Ô
Entering Your Area Code
When the area code has
already been stored in
memory, the stored area
code will be displayed. To
change it, use the
DELETE/TRANS and
number keys to enter the
new area code. Then press
SELECT/CH. A
confirmation tone sounds.
To complete the setting,
press END or return the
handset to the base unit.
Choosing the Dialing
Mode
Dialing mode can only be
changed from handset 1
(HS1). To confirm which
handset is HS1, look at the
display indicating
HS1
or
HS2
.