Filter
Top Products
Installation
10
CONNECTING/CHARGING THE
BATTERY PACK
The phone comes with a rechargeable
nickel-cadmium battery pack in the handset,
but not connected. Before using your
phone, you must connect the battery pack.
Then charge it for about 15–20 hours.
!
1. Press down and slide off the battery
compartment cover.
2. Lift the battery pack out of the
compartment.
3. Plug the battery pack’s connector into
the socket in the compartment (the
connector fits only one way). Then
place the battery pack in the
compartment.
4. Replace the cover.
To charge the battery pack, place each
handset on the base or charging cradle. The
CHARGE/IN USE and CHARGE indicators on
the cradles should light up.
!
Ô
Recharge the battery pack when
Low
Battery
flashes on the display. Ô
When you first use the phone after charging
or recharging the battery pack, the phone
might not work and you might hear error
beeps. If this happens, place both handsets
on the main base.
Using a damp cloth, clean the charging
contacts on the handsets and cradles about
once a month.
!
IMPORTANT
!
• The EPA
certified
RBRC
®
Battery
Recycling
Seal on the nickel-
cadmium (Ni-Cd)
battery indicates
RadioShack is
voluntarily participating
in an industry program
to collect and recycle
these batteries at the
end of their useful life,
when taken out of
service in the United
States or Canada. The
RBRC program
provides a convenient
alternative to placing
used Ni-Cd batteries
into the trash or the
municipal waste stream,
which may be illegal in
your area. Please call 1-
800-THE-SHACK (1-
800-843-7422) for
information on Ni-Cd
battery recycling and
disposal bans/
restrictions in your area.
RadioShack’s
involvement in this
program is part of the
company’s commitment
to preserving our
environment and
conserving our natural
resources.
• Be sure the battery pack
is properly connected
before you try to charge
it. The CHARGE/IN
USE or CHARGE
indicator lights when the
handset is on the cradle,
even if the battery pack
is not connected.