Filter
Top Products
SAFETY AND REGULATIONS 4 – 3
13.Do not disassemble this product, but return to Polycom Certified Service Center
when service or repair is required.
14. Avoid using this product during an electrical storm. There may be a remote risk of
electric shock from lightening.
15.Do not use a telephone in the vicinity of a gas leak.
Save these Instructions
The information contained in this manual will help you operate and maintain your
SoundPoint Pro.
FCC Rules
This equipment complies with Part 68 of the FCC Rules. On the bottom of the base of
this equipment is a label that contains, among other information, the FCC Registration
Number and Ringer Equivalence Number (REN) for the equipment. You must, upon
request, provide this information to your telephone company. (Note: REN is not
required for some types of analog or digital facilities.)
This equipment uses an RJ11.
An FCC compliance telephone cord and modular plug is provided with this equip-
ment. This equipment is designed to be connected to the telephone network or premis-
es wiring using a compatible modular jack which is Part 68 compliant. See installation
instructions for details.
The REN is useful to determine the quantity of devices you may connect to your tele-
phone line and still have all those devices ring when your telephone number is called.
In most, but not all areas, the sum of the REN’s of all devices connected to one line
should not exceed five (5). To be certain of the number of devices you may connect to
your line, as determined by the REN, you should contact your local telephone compa-
ny to determine the maximum REN for your calling area. (NOTE: REN are associat-
ed with loop-start and ground-start ports. Do not use for E&M or digital ports.)
If your telephone equipment causes harm to the telephone network, the Telephone
Company may discontinue your service temporarily. If possible, they will notify you
in advance. But if advance notice is not practical, you will be notified as soon as pos-
sible. You will be informed of your right to file a complaint with the FCC.
Your telephone company may make changes in its facilities, equipment, operations or
procedures that could affect the proper functioning of your equipment. If they do,
you will be notified in advance to give you an opportunity to maintain uninterrupted
telephone service.
Safety, Regulatory and Warranty
4 – 2 SAFETY AND REGULAT I O N S
Intended Use
Important Safeguards
Before operating this product, please read the entire manual thoroughly. The
SoundPoint Pro was designed, built and tested for use indoors using Polycom brand
accessories and peripherals and nominal local voltages. The use of other equipment
with this product, outdoor operation or different voltages has not been tested and
could damage it or peripheral equipment and/or create a potentially unsafe operating
condition.
1. Read and understand all instructions before using. Pay particular attention to areas
labeled as Warnings or Cautions.
▼ Warning - Indicates a potentially hazardous situation which, if not avoided,
could result in death or injury.
▼ Caution - Indicates a potentially hazardous situation which , if not avoided,
could result in minor or moderate injury. It may also be used to alert against
unsafe practices.
2. Close supervision is necessary when any equipment is used by or near children.
3. Do not operate this product with a damaged cord or if it has been dropped or
damaged - until it has been examined by a qualified service technician.
4. Position the cord so that it will not be tripped over, pulled or contact hot surfaces.
5. If an extension cord is necessary, a cord with a current rating at least equal to that
of the product should be used. Cords rated for less amperage than the product may
overheat.
6. To reduce the risk of electric shock, do not immerse this product in water or other
liquids.
7. To reduce the risk of electric shock, do not disassemble this product. Take it to a
qualified technician when service or repair work is required. Incorrect reassembly
can cause electric shock.
8. The use of an accessory attachment not recommended by the manufacturer may
cause a risk of fire, electric shock or injury.
9. Keep ventilation openings free of any obstructions.
10.Do not place this product on an unstable cart, stand or table. Doing so may cause
the product to fall, causing serious damage.
11.If this product does not operate normally, see “In Case of Difficulty” on page 1-5.
12.Do not overload wall outlets and extension cords as this can result in increased
risk of fire or electric shock.
Safety, Regulatory and Warranty