Filter
Top Products
GETTING STA R TED 1 – 5
Installing the Phone
Setup 1 - Three lines, three jacks.
1. Plug one end of a gray telephone cord into the wall jack and the other end into
line port L1 of the LIM.
2. Repeat step 1 for lines 2 and 3:
▼ For line 2, connect a second wall jack to port L2 of the LIM.
▼ For line 3, connect a third wall jack to port L3 of the LIM.
3. Connect one end of the SoundPoint Pro black console telephone line to the LIM
and the other end to the console.
4. Connect the Power Adapter cord to the SoundPoint Pro console, and plug the
power brick into the electrical outlet.
Installation
1 – 4 GETTING STA RT E D
Installation of SoundPoint Pro is easy. Refer to the Quick Installation Sheet that came
with your phone, or follow the directions below.
Preparing for Installation
Preparing to install your phone includes deciding where you want to install the phone,
locating the power outlet closest to your phone, locating your existing telephone wall
j a ck(s) in your home or offi c e, and determining how your telephone lines are confi g u re d
with your telephone jacks. Three examples are shown, with 3 different configurations
of wall jack(s).
S o u n d Point Pro ’s Line Interface Module (LIM) allows you to connect multiple telep h o n e
lines to SoundPoint Pro, with only one cable connecting to the console.
Note: If one or more
of your telephone lines
are terminated on one
telephone cable, you
may wish to connect
the console cable
directly to the single
telephone jack, without
using the LIM (see
Setup 2).
The following diagram shows the standard cable lengths to help you plan your
configuration. If you require longer cables, you can find them at most hardware and
electronics stores.
Note: All telephone
cables are 6-wire RJ11.
Installation