Filter
Top Products
Sensaphone
®
Model 1108 User’s Manual
72
6.2.1 Example: Status Report, No Alarms
Inputs 2, 3, 4, and 6 are configured as dry contact and inputs 1,
5, 7 and 8 are configured as temperature. No alarms exist. The
Status Report begins by saying, “Hello, this is telephone
number 555-1234; the time is 12:15 PM.” Following this
introduction, the report continues:
“Number 1, 74 degrees, OK.”
“Number 2, OK.”
“Number 3, OK.”
“Number 4, OK.”
“Number 5, 76 degrees, OK.”
“Number 6, OK.”
“Number 7, 86 degrees, OK.”
“Number 8, 70 degrees, OK.”
“The electricity is ON.” This refers to AC power.
“Battery condition, OK.” Other responses: “Battery condition
low” or “Replace batteries.” (Refer to Section 6.2.4 for
additional information regarding battery condition.)
“Sound level, OK.”
“Listen to the sound level for 10 seconds.” In this case, the
programmed Listen-in Time is set at 10 seconds. (This feature
is not available when obtaining the Status Report on-site,
directly at the keypad.)
The Status Report repeats once more and the Model 1108
concludes the call, saying: “Have a good day.” (The Status
Report will not repeat if obtained at the keypad; “Have a good
day,” is also not recited.)
The phrase “no number” at the end of a Status Report indicates
that no dial-out phone numbers have been programmed.