Filter
Top Products
Sensaphone
®
Model 1108 User’s Manual
88
Communications / Dial-out:
Problem
Solution
Cause
6. The Model 1108 and telephone
answering device (sharing the
same line) answer incoming calls
simultaneously.
The Model 1108
’
s number of Rings Until
Answer is set to equal the number of rings
set for the telephone answering device.
Change the number of Rings Until Answer
for the Model 1108. Refer to Chapter 4,
Section 4.5.
5. The Model 1108 dials out
correctly but fails to audibly recite
its alarm message when you
answer the call.
Voice Reps is set to zero.
Reprogram Voice Reps to 1 or greater.
Refer to Chapter 4, Section 4.10.
4. The Model 1108 recites the alarm
message or Status Report over the
telephone, but is silent at the
installation site.
The local voice mute feature is in effect.
Deactivate local voice mute. Refer to the
programming steps in Chapter 4,
Section 4.9.
When calling the Model 1108, and the TAD
is disabled, allow the telephone to ring 10
times. Refer to Chapter 6, Section 6.1.3,
and Chapter 4, Section 4.6.3.
You did not allow the telephone to ring
10 times. Note: If the TAD (telephone
answering device) is disabled, the telephone
rings ten times before the Model 1108
answers. If the TAD is enabled, the
telephone rings once before the Model 1108
answers the call.
3. The Model 1108 will not answer
the telephone for Callback
Acknowledgement.
(Continued from previous page)