Filter
Top Products
71
Chapter 6: Acknowledgment, Status Report, and Remote Access
NOTE
If you have the TAD feature ( telephone
answering device) enabled, the Model 1108 will
answer the telephone on the first ring. If it is
disabled, the telephone must be allowed to ring
10 times. This serves as a precaution against a
random alarm acknowledgment. Refer to
Chapter 4, Section 4.6, for complete information
on using the TAD feature.
6.2 Status Report
The Status Report allows access to complete information on all
monitored conditions either locally, from the keypad, or by
telephone, from any location. The Model 1108 will answer an
incoming telephone call following the programmed Rings Until
Answer (refer to Chapter 4, Section 4.5). Included with the
Status Report are messages related to alarm conditions,
AC power, battery backup and sound level. It also provides an
opportunity for listening to on-site sounds (refer to Listen-in
Time, Chapter 4, Section 4.7).
To initiate the Status Report:
1. Press WHAT IS.
WHAT
IS
*
2. Press STATUS.
STATUS
CONFIGURE
Sections 6.2.1, 6.2.2, and 6.2.3 demonstrate two different
Status Report recitations. The Status Report starts with:
“Hello. This is telephone number 555-1234 (or the
programmed ID).”
“The time is 12:15 PM (or the current time).”
The Model 1108 proceeds with a separate report for each input.
Each input identifies itself by reciting the input number.