Filter
Top Products
Sensaphone
®
Model 1104 User’s Manual
72
“The time is 12:15 PM (or the current time).”
The Model 1104 proceeds with a separate report for each input.
Each input identifies itself by reciting the input number.
6.2.1 Example: Status Report, No Alarms
Inputs 2, 3, and 4 are configured as dry contact and input 1 is
configured as temperature. No alarms exist. The Status Report
begins by saying, “Hello, this is telephone number 555-1234;
the time is 12:15 PM.” Following this introduction, the report
continues:
“Number 1, 74 degrees, OK.”
“Number 2, OK.”
“Number 3, OK.”
“Number 4, OK.”
“The electricity is ON.” This refers to AC power.
“Battery condition, OK.” Other responses: “Battery condition
low” or “Replace batteries.” (Refer to Section 6.2.4 for
additional information regarding battery condition.)
“Sound level, OK.”
“Listen to the sound level for 10 seconds.” In this case, the
programmed Listen-in Time is set at 10 seconds. (This feature
is not available when obtaining the Status Report on-site,
directly at the keypad.)
The Status Report repeats once more and the Model 1104
concludes the call, saying: “Have a good day.” (The Status
Report will not repeat if obtained at the keypad; “Have a good
day,” is also not recited.)
The phrase “no number” at the end of a Status Report
indicates that no dial-out phone numbers have been
programmed.