Filter
Top Products
Sensaphone
®
Model 1104 User’s Manual
36
Using the procedure just outlined, all incoming calls will be
answered by the telephone answering device, allowing it to
operate normally. With the programming just accomplished, the
Model 1104 can be accessed remotely, by telephone, to obtain
the Status Report.
1. Dial the telephone number of the Model 1104.
2. Let the telephone ring once and then hang up.
3. Wait approximately ten seconds
4. Call the Model 1104 back.
It will answer the telephone on the first ring.
Explanation: The pattern of one ring, followed by a second call
(within 30 seconds), signals the Model 1104 to answer your
incoming call, excluding the telephone answering device.
NOTE
Special Case: If the Model 1104 shares the same
line with a telephone answering device, and
during certain time periods, frequent, incoming
calls are expected on that line, then you may
want to temporarily disable the TAD feature. If
you leave the TAD enabled, it will not adversely
affect normal operation, but if two outside
telephone calls are received within the same
30-second time window, the Model 1104 will
interpret this pattern as a signal to answer the
telephone. If this occurs, press any key on the
Model 1104 to hang up.
4.6.3 No TAD In Use
If a telephone answering device is not used on the same
telephone line as the Model 1104, make sure that the
TAD feature is disabled, or turned off. Only Rings Until
Answer programming will determine how incoming calls
are answered. For example, if you program Rings Until
Answer to 3, incoming calls will be answered in 3 rings.