Filter
Top Products
23
Preparation
For assistance, please call: 1-800-211-PANA(7262)
• You can exit the programming mode any time by pressing [EXIT].
• If set to OFF, “Ringer off” with the line(s) (“”, “” and/or “INT”) is(are)
displayed while the unit is not in use (standby mode).
• You can also change each ringer volume while the unit is just ringing for the
external/intercom line, by pressing VOLUME [] or []. To turn the ringer OFF,
press and hold VOLUME [].
• You can change the ringer tone for Line 1, Line 2 and Intercom individually
(see below).
Ringer Pattern
You can select one of eight ringer tones for Line 1, Line 2 and Intercom
individually. For Intercom you can select another ringer pattern (Voice
mode, Auto Answer mode or Room Monitor mode), instead of the ringer
tone.
Line 1 is preset to “1”, Line 2 is preset to “2” and Intercom is preset to “3”.
• When a paging extension pages all extensions, this ringer pattern setting is not
applicable (p. 48).
(Continued )
Ringer pattern
How the unit works when a call is being received.
Ringer tone (1 to 8) The unit rings with the selected ringer tone.
Voice mode
(for Intercom only)
Two short beeps sound, then you are paged with
the caller’s voice instead of the bell. To answer
the page, press [SP-PHONE/HEADSET] or lift
the handset.
Auto Answer mode
(for Intercom only)
Two short beeps sound, then the speakerphone
turns on automatically, in response to the page.
Without pressing any button, 2-way intercom with
the paging party is established automatically.
Room Monitor mode
(for Intercom only)
Selecting the Room Monitor mode allows
another extension user to monitor through your
unit. Another extension can call your unit to
monitor a room through it (p. 49). Your unit will
not ring and the SP-PHONE/HEADSET
indicator will light. If you want to prevent your
unit from being monitored by other extensions,
do not select this mode.
1
2
>
<
<