Filter
Top Products
Error messages
Display message Cause/solution
Base no power
o
r
No link. Re-connect base
AC adaptor.
or
No link.
R T
he handset has lost communication with the base
unit. Move closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset’s registration may have been canceled.
Re-register the handset (page 66).
R When “No link.” is displayed during a power
failure, place a handset on the base unit to supply
power to the base unit.
Busy
R N
o cellular phone is paired to the base unit. Pair a
cellular phone (page 14).
R The called unit is in use.
R Other unit is in use and the system is busy. Try again
later.
R The handset you are using is too far from the base
unit. Move closer and try again.
Call phone company for
y
our access #
R You have not stored the voice mail access number.
Store the number (page 55).
Check tel line
R T
he supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 8).
R If you do not connect the telephone line cord and use
only cellular lines, set the cellular line only mode
(page 16).
Error!!
R R
ecording was too short. Try again.
R Someone is using a cellular line or headset. Try
again later.
R The phonebook copy is incomplete (page 45). The
cellular phone is disconnected from the base unit.
Make sure that other Bluetooth devices are not
connected to the cellular phone, and try again.
Failed
R A
lthough the unit tried to connect to the cellular
phone or headset, the connection has been failed.
– Someone is using a cellular line or headset. Try
again later.
– Make sure that the cellular phone or headset is
not connected to other Bluetooth devices.
Invalid
R T
he handset is not registered to the base unit.
Register the handset (page 66).
Requires subscription to
C
aller ID.
R You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
59
Useful Information
TG7841BX_UE(en)_0528_ver011.pdf 59 2013/05/28 18:56:50