Filter
Top Products
Link to cell settings
Selecting which unit receives
c
ellular calls
You can select which unit rings and receives
calls for a cellular line. When “All” is
selected, the handset and the base unit ring.
Handset
1 F
or CELL 1: MMENUN#6271
For CELL 2: MMENUN#6272
2 MbN: Select the handset or “All”. a
MSAVEN
3 MOFFN
Note:
R When you select the handset to receive
calls for a cellular line the base unit can
answer the calls even though it does not
ring. However, you can make the base unit
ring by adjusting the base unit ringer
volume (page 33).
R When you change the setting to “All”, the
base unit ringer volume also returns to the
lowest level even if the ringer volume has
been changed.
Ring as cell mode
O
nce this feature is turned on, the handset
and base unit ring using the same ringer tone
as your cellular phone.
The following settings are available:
– “Off”: Turn this feature off to use the
ringer tones of the handset and base unit.
Caller information is announced depending
on the Talking Caller ID setting (page 35).
– “On (with Talking CID)” (default):
The handset and base unit use your cellular
phone’s ringer tone. Caller information is
announced even if the Talking Caller ID is
turned off.
– “On (without Talking CID)”: The
handset and base unit use your cellular
phone’s ringer tone. Caller information is
not announced even if the Talking Caller ID
is turned on.
Important:
R T
o use this feature, your cellular phone
must support Bluetooth in-band ringtone.
Refer to your cellular phone’s operating
instructions.
Handset
1 F
or CELL 1: MMENUN#6141
For CELL 2: MMENUN#6142
2 MbN: Select the desired setting.
3 MSAVEN a MOFFN
Note:
R The units use the preset ringer tones
(page 34) instead of your cellular phone’s
ringer tone when a cellular call is being
received if:
– your cellular phone is in night mode
(depending on your cellular phone).
– the base unit is in use.
R If your cellular phone is in night mode with
“On (with Talking CID)” set, the unit
announces caller information even when
Talking Caller ID is turned off (page 35).
To use the handset ringer tone
i
nstead of your cellular phone’s
ringer tone
Select “Off” in step 2, “Ring as cell mode”,
page 15.
To change the handset ringer tone for a
cellular line, see page 33.
Auto connection to the cellular
p
hone
After pairing, your cellular phone is connected
to the base unit. If you move the cellular
phone out of base unit range, the cellular
phone is disconnected from the base unit.
This feature allows the base unit to try to
reconnect the cellular phone at regular
intervals when it returns within base unit
range. You can set the interval. The default
setting is “1 min”.
Important:
R When you are using a cellular line or a
Bluetooth headset, the base unit loses its
15
Link to Cell
TG7841BX_UE(en)_0528_ver011.pdf 15 2013/05/28 18:56:47