Filter
Top Products
85
Useful Information
Problem
You cannot operate the
answering system from a
touch tone phone.
You cannot operate the
answering system with the
handset.
While recording a greeting
message, the unit starts to
ring and stops recording.
During playback, the unit
starts to ring and stops
playback.
The base unit does not
display the name and/or
number of the caller whose
message is being played.
The unit does not alert your
pager.
Remedy
•Make sure you enter the correct remote
code.
•The answering system may not respond
if the tones are too short to activate the
unit. Press each button firmly.
•The answering system is off. Turn it on
(p. 69).
•Someone is operating the answering
system.
•You are too far from the base unit. Move
closer to the base unit.
•The unit is recording a message.
To answer the call, press or .
•To answer the call, press
(DIGITAL!SP-PHONE), or lift the handset
off the base unit or press or .
Start again from the beginning after
hanging up.
•To answer the call, press
(DIGITAL!SP-PHONE), or lift the handset
off the base unit or press or .
To resume playback, press
(NEW!MESSAGE) after hanging up.
•If the caller is not stored in the Caller
List, the handset will not display the
caller’s information.
•The line mode selection is incorrect.
See page 14.