Filter
Top Products
Settings
14
Selecting the Line Mode
If the line is connected to a low voltage system such as a PBX, set to “B”.
Otherwise the Call Waiting Caller ID Feature may not be used (p. 52), and
the unit may not alert your pager (p. 58). Your phone comes from the
factory set to “A”. Use the handset near the base unit.
Make sure the unit is in the standby mode initially.
1
Press (FUNCTION/CH).
2
Press Ö or Ñ repeatedly until the arrow
points to “Program”.
3
Press á (Yes key).
4
Press Ö or Ñ repeatedly until the arrow
points to “Set line mode”.
5
Press á (Yes key).
6
Press Ö or Ñ to select “B” or “A”.
7
Press á (Save key).
•A beep sounds.
•To return to the standby mode, press (OFF).
•You can exit the programming mode any time by pressing (OFF).
•If the handset has lost communication with the base unit, an alarm tone sounds
and “No link to base. Place on cradle and try again.” is
displayed.
•If 3 beeps sound and the display shows “Save error”, move closer to the base
unit and start again from step 1.
H
Set line mode
Talk switching
GF H
=Yes
Line mode
:A
GF H
=Save
Line mode
:B
H
Save directory
Ringer volume
GF H
=Yes
H
Program
Calling pager
GF H
=Yes
H
Save DIRECT#
Set flash time
GF H
=Yes
Line mode
:B
GF H
=Save