Filter
Top Products
83
Useful Information
Problem
The unit does not display the
caller’s name and/or phone
number.
The handset or the base unit
display goes to the standby
mode while viewing the
Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller’s
name and/or phone number.
You cannot page the
handset or the base unit.
You cannot redial by
pressing (REDIAL/PAUSE) or
(REDIAL).
Remedy
•You need subscribe to a Caller ID
service from telephone companies.
•Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
•Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
•Telephone line noise may be affecting
the Caller ID information.
•Do not pause for over 60 seconds while
searching.
• , or (DIGITAL!SP-PHONE).
was pressed.
•The line mode selection is incorrect. See
page 14.
•The handset is too far from the base unit.
•The handset or the base unit is engaged
in an outside call or is viewing the Caller
List/directory list. Try again later. If you
are using the base unit, wait until
“Handset in use” disappears.
•If the last number dialed was more than
32 digits long, the number will not be
redialed correctly.
•Access numbers entered after pressing
(TONE) will not be included when
redialing.
•The (REDIAL/PAUSE) button on the
handset has a double function as either
redial or pause. It will redial the last
number dialed if pressed at the outset of
a call (p. 27). If another number has
been dialed first, it will operate as a
pause button (p. 52).