Filter
Top Products
58
Pager Call
This feature allows you to alert your pager when the unit records an
incoming message or receives a Caller ID call (p. 32). You can retrieve
the message from a touch tone telephone (p. 64). If you subscribe to a
Caller ID service, the caller’s telephone number will be displayed on your
pager. First program the following settings (p. 58–62), then set the unit to
call the pager. Use the handset near the base unit.
Make sure that the unit is in the standby mode initially.
Storing a Pager Number
If you use a 1-800 pager number, see the next page for the storing
procedure.
1
Press (FUNCTION/CH).
2
Press Ö or Ñ repeatedly until the arrow
points to “Program”.
3
Press á (Yes key).
4
Press Ö or Ñ repeatedly until the arrow
points to “TAD program”.
5
Press á (Yes key).
•The base unit display shows programming
options.
6
Press (#).
7
Enter your pager number, and press (REDIAL/PAUSE) twice.* Enter
the access code, if required by your pager company, and press
(REDIAL/PAUSE) twice again.*
•The entered number is displayed on the base unit.
•If you misdial, press (CLEAR) and enter the correct number.
•You can enter a total of 44 digits.
Set dial mode
H
TAD program
GF H
=Yes
Answering
system setting.
See base unit.
Enter pager no.
Base unit display
H
Program
Calling pager
GF H
=Yes
H
Save DIRECT#
Set flash time
GF H
=Yes