Filter
Top Products
63
Answering System
Setting the Unit to Call a Pager
1
Press (FLASH/CALL!WAIT/PLAYBACK).
•The number of new messages
is heard on the handset.
2
Press (3).
•“” is displayed on the
base unit.
•If “” is not displayed, the
pager number has not been
stored. Store the number
(p. 58, 59), and try again.
3
Press (FLASH/CALL!WAIT/PLAYBACK).
To turn off the pager call mode,
repeat steps 1 through 3.
•“” will disappear.
•Each time you press (3) in step 2, the
mode will turn on or off.
PAGER
PAGER
PAGER
•If another message (or Caller ID call) is received before the unit alerts your pager
for a previous message (or Caller ID call), the previous caller information will not
be sent to your pager. Only the last call received will be sent to your pager.
•If someone else makes or answers another call with the unit or a parallel
connected phone before the unit alerts your pager for a previous message (or
Caller ID call), the unit will stop alerting your pager for that message (or Caller ID
call).
•If you receive a telephone number on your pager but cannot recognize the caller,
you may have received a direct inward dial (DID) call, such as from a PBX.
Please call your unit to check the caller’s message.
If you have not subscribed to a Caller ID service, the caller’s
telephone number will not be displayed on your pager.
(FLASH/CALL!WAIT/PLAYBACK)